A solid metal cube of edge length 2 cm is moving in a positive y-direction at a constant speed of 6 m/s. There is a uniform magnetic field of 0.1 T in the positive z-direction. The potential difference between the two faces of the cube perpendicular to the x-axis, is -

A charge Q is distributed over three concentric spherical shells of radii a, b, c (a < b < c) such that their surface charge densities are equal to one another. The total potential at a point at distance r from their common centre, where r < a, would be -

If the magnetic field of a plane electromagnetic wave is given by (the speed of light = 3 × 10⁸ B = 100 × 10^–6 sin $$\left[ {2\pi \times 2 \times {{10}^{15}}\left( {t - {x \over c}} \right)} \right]$$ then the maximum electric field associated with it is -

A 2 W carbon resistor is color coded with green, black, red and brown respectively. The maximum current which can be passed through this resistor is -

A homogeneous solid cylindrical roller of radius R and mass M is pulled on a cricket pitch by a horizontal force. Assuming rolling without slipping, angular acceleration of the cylinder is -

A string of length 1 m and mass 5 g is fixed at both ends. The tension in the string is 8.0 N. The string is set into vibration using an external vibrator of frequency 100 Hz. The separation between successive nodes on the string is close to -

In an electron microscope, the resolution that can be achieved is of the order of the wavelength of electrons used. To resolve a width of 7.5 × 10^–12 m, the minimum electron energy required is close to -

A plano convex lens of refractive index $$\mu $$₁ and focal length ƒ₁ is kept in contact with another plano concave lens of refractive index $$\mu $$₂ and focal length ƒ₂. If the radius of curvature of their spherical faces is R each and ƒ₁ = 2ƒ₂, then $$\mu $$₁ and $$\mu $$₂ are related as -

An insulating thin rod of length $$l$$ has a linear charge density $$\rho \left( x \right)$$ = $${\rho _0}{x \over l}$$ on it. The rod is rotated about an axis passing through the origin (x = 0) and perpendicular to the rod. If the rod makes n rotations per second, then the time averaged magnetic moment of the rod is -

The density of a material in SI units is 128 kg m^–3 . In certain units in which the unit of length is 25 cm and the unit of mass is 50 g, the numerical value of density of the material is -

A piece of wood of mass 0.03 kg is dropped from the top of a 100 m height building. At the same time, a bullet of mass 0.02 kg is fired vertically upward, with a velocity 100 ms^–1, from the ground. The bullet gets embedded in the wood. Then the maximum height to which the combined system reaches above the top of the building before falling below is - (g = 10 ms^–2)

In a Young’s double slit experiment with slit separation 0.1 mm, one observes a bright fringe at angle $${1 \over {40}}$$ by using light of wavelength $$\lambda $$₁. When the light of wavelength $$\lambda $$₂ is used a bright fringe is seen at the same angle in the same set up. Given that $$\lambda $$₁ and $$\lambda $$₂ are in visible range (380 nm to 740 nm), their values are -

In a Young’s double slit experiment with slit separation 0.1 mm, one observes a bright fringe at angle $${1 \over {40}}$$ by using light of wavelength $$\lambda $$₁. When the light of wavelength $$\lambda $$₂ is used a bright fringe is seen at the same angle in the same set up. Given that $$\lambda $$₁ and $$\lambda $$₂ are in visible range (380 nm to 740 nm), their values are -

Water flows into a large tank with flat bottom at the rate of 10^–4m³s^–1. Water is also leaking out of a hole ofarea 1 cm² at its bottom. If the height of the water in the tank remains steady, then this height is -

A magnet of total magnetic moment 10^-2 $${\widehat i}$$ A-m² is placed in a time varying magnetic field, B$${\widehat i}$$ (cos $$\omega t$$) where B = 1 Tesla and $$\omega $$ = 0.125 rad/s. The work done for reversing the direction of the magnetic moment at t = 1 second, is -

A parallel plate capacitor is of area 6 cm² and a separation 3 mm. The gap is filled with three dielectric materials of equal thickness (see figure) with dielectric constants K₁ = 10, K₂ = 12 and K₃ = 14. The dielectric constant of a material which when fully inserted in above capacitor, gives same capacitance would be -

To mop-clean a floor, a cleaning machine presses a circular mop of radius R vertically down with a total force F and rotates it with a constant angular speed about its axis. If the force F is distributed uniformly over the mop and if coefficient of friction between the mop and the floor is $$\mu $$, the torque, applied by the machine on the mop is -

In the cube of side ‘a’ shown in the figure, the vector from the central point of the face ABOD to the central point of the face BEFO will be -

A satellite is moving with a constant speed v in circular orbit around the earth. An object of mass ‘m’ is ejected from the satellite such that it just escapes from the gravitational pull of the earth. At the time of ejection, the kinetic energy of the object is -

A heat source at T = 10³ K is connected to another heat reservoir at T = 10² K by a copper slab which is 1 mthick. Given that the thermal conductivity of copper is 0.1 WK^–1m^–1, the energy flux through it in the steady state is -

Two guns A and B can fire bullets at speeds 1 km/s and 2 km/s respectively. From a point on a horizontal ground, they are fired in all possible directions. The ratio of maximum areas covered by the bullets fired by the two guns, on the ground is -

To get output 1 at R, for the given logic gate circuit the input values must be

In the given circuit the cells have zero internal resistance. The currents (in Amperes) passing through resistance R₁ and R₂ respectively, are -

A block of mass m is kept on a platform which starts from rest with constant acceleration g/2 upward, as shown in figure. Work done by normal reaction on block in time is -

Two electric dipoles, A, B with respective dipole moments $${\overrightarrow d _A} = - 4qai$$ and $${\overrightarrow d _B} = - 2qai$$ are placed on the x-axis with a separation R, as shown in the figure. The distance from A at which both of them produce the same potential is -